Harz Labs Dental 3D printing resin for Desktop SLA / Form2

Description

Harz Labs Dental 3D printing resin for Desktop SLA / Form2

Form2 Model (Grey, White,Clear) :For models with high requirements in mechanical properties
Form2 Dental Clear: For transparent models of aligners and SG modelling
Form2 Dental Sand A1-A2: For creating models of temporary crowns and bridges
Form2 Dental Cast Cherry: For direct casting
Form2 Dental Peach: For printing jaws master-models

This 3D printing resin is low odor and absence of harmful monomers allows to print in the laboratory.

 

Russian certification. No European certification, to be used only for models.

For more info write to us at: info@3dsolutions.store.

 

3D printing settings on most widespread 3D printers

click here

 

• UNIQUE MECHANICAL PROPERTIES

  Very high hardness, tensile strength, abrasion and scratch resistance due to ceramic fillers.

• LOW VISCOSITY

  The resin has relatively low viscosity. It decreases time for levelling, easy to clean to provide maximum accuracy at minimum time.

• CHEMICAL RESISTANCE

  Resin is stable to solvents, aggressive inorganic agents like acid and alkalis.

• ODORLESS

  Resins are odorless and cause no irritation, so you can work with natural ventilation.

• LOW SHRINKAGE

  Shrinkage less than 0.5% gives you the same size of the 3D model on your computer

• BIOCOMPATIBLE

  Produced from biocompatible raw material used in photopolymer teeth fillings. Meets the standards ISO 10993. 

• DURABLE

  Pigments and fillers are well stabilized, no sedimentation and flocculation occur and no foam appears

Finishing Instructions

1. Agitate in a bath with TEK1960* solvent for 1-2 minutes to remove excess resin.

2. Do not soak in acetone. Do not leave the 3D part soaking in the liquid. Use a soft brush if necessary.

3. Clean off any excess of liquid with a cold blowdryer or compressed air.

4. Leave under the sun or in a UV lamp to cure. The resin is fully cured when fingernails do not leave scratch marks on the object.

*We do not recommend the use of denatured or isopropyl alcohol (IPA). It is very aggressive on the polymerized resin and it could weaken the structure of the 3D part. It is also flammable and potentially harmful to people and the environment.

Store the resin in a dry, cool, shaded place out of direct sunlight.

Safety notice

The company I.D.M di Marin Davide is not a manufacturer of medical materials or devices. The material sold on this site is neither produced nor controlled by the company I.D.M. di Marin Davide, who in no case can be held responsible for any damage caused by use or application of the material, which must only be used on suitable machines and by specialized personnel, exclusively for the purpose indicated, according to the manufacturer’s instructions. For resins with European certification, the properties of the finished product vary according to the entire printing and post-curing process; refer to the manufacturer for any information about it.

 

 More Information                     MSDS