TEK 1969 cleaner

12.50

Post-processing greener alternative to IPA for non-professional resins.

 

Out of stock

Description

TEK 1969 cleaner for stereolithography 3D printers

Cleaning liquid for post-processing of non-professional 3D printing resins.

No more hazardous, polluting and unsafe post processing procedures, because we care about health and environment!

Make your 3D printing greener with TEK 1969, a cleansing liquid which does not dissolve the resin, but it simply separate the uncured resin from the polymerized one.

Methods of Use:

  1. Ultrasonic cleaning at 40°C (suggested for a more effective use)

  2. Magnetic stirrer

  3. Manual with immersion in a container and shake by hand until the resin will be detached from the workpiece.

How to use it in ultrasonic bath

  • Put the liquid into the ultrasonic vessel

  • Operate the vessel for 1 minute before cleaning operation

  • Insert the molded parts to at least 5 minutes into the vessel

  • Flush with demineralised water (for transparent parts go direct to next point)

  • Blow dry object with compressed air.

  • Remove supports if the object is cured enough. (otherwise wait till after the post curing)

The liquid can be filtered with a cloth, or with a TNT (non-woven fabric). TEK 1969 has evaporation rate similar to water: add new liquid when needed.

TEK 1969 is not suitable for professional resins. It is an excellent product for titanium cleansing.

1 litre pack

 

 

 

Additional information

Weight 1.5 kg
Dimensions 10 × 10 × 30 cm
COLORS

RED, BLACK, UNPIGMENTED

Reviews

There are no reviews yet.

Be the first to review “TEK 1969 cleaner”

Your email address will not be published. Required fields are marked *

Slide to unlock *

This site uses Akismet to reduce spam. Learn how your comment data is processed.