With only a 0.5 % shrinkage this 3D printing resin is a perfect choice for with artistic prints. It has the look and feel of injection moulded plastic. As FunToDo team state “When we say black, we mean black, deep black, with no discoloration in even the finest detail. Because of the very small, near nano particle pigmentation, ‘Deep Black’ has an ultra-high definition,”
3D printing resin FunToDo Deep Black characteristics
|Viscosity||at 25°C||80 mPa.s|
|Hardness (Shore D)||81|
To clean and remove excess resin, agitate the 3D printed part in a simple bath with TEK1960 solvent* for 1-2 minutes until all excess resins has been removed.
Do not soak in acetone. Do not leave the 3D part soaking in the liquid. Use a soft brush if necessary.
Clean off any excess of liquid with a cold blowdryer or compressed air.
Leave under the sun or in a UV lamp to cure. The resin is fully cured when fingernails do not leave scratch marks on the object.
*We do not recommend the use of denatured or isopropyl alcohol (IPA). It is very aggressive on the polymerized resin and it could weaken the structure of the 3D part. It is also flammable and potentially harmful to people and the environment.
Store the resin in a dry, cool, shaded place out of direct sunlight.
More information is available at FunToDo.
The company I.D.M di Marin Davide is not a manufacturer of medical materials or devices. The material sold on this site is neither produced nor controlled by the company I.D.M. di Marin Davide, who in no case can be held responsible for any damage caused by use or application of the material, which must only be used on suitable machines and by specialized personnel, exclusively for the purpose indicated, according to the manufacturer’s instructions. For resins with European certification, the properties of the finished product vary according to the entire printing and post-curing process; refer to the manufacturer for any information about it.