Industrial Blend 3D printing resin can withstand very low and very high temperatures (tested from -45˚C to 225˚C)- suitable for any test environment. This also makes the Industrial Blend Resin one of the only resins that has been used for vulcanisation
The Industrial Blend resin works with any light source with a wavelength of 225nm to 415nm – this means there is no need to modify DLP 3D printers. Industrial Blend resin also work reliably with some models of SLA 3D printers.
A DLP Printer with a 180 watt lamp will cure a 0.05mm layer in approximately 2 seconds. A 240 watt lamp will cure a 0.05mm layer in half a second. With the Industrial Blend resin you have hardening times among the fastest of all the resins on the market.
Super easy to use
The Industrial Blend resin comes ready to use with pigments already optimised and mixed in.
After initial calibration, there is nothing else to worry about. Special formulation has brought down average shrinkage on these resins to approximately 0.5% (the industry average is 3.5%).
The Industrial Blend resin have a very faint odour and cause minimal skin irritation as compared to other resins.
When fully cured the Industrial Blend resin has a hardness of approximately 75 shore D (what does this mean?). Industrial Blend resin has also been tested and proven to withstand a myriad of different chemicals including water, acetone, alcohol and thinner.
3D printing resin FunToDo Industrial Blend characteristics
|Viscosity||at 25°C||95 mPa.s|
|Hardness (Shore D)||75|
To clean and remove excess resin, agitate the 3D printed part in a bath with TEK1960 solvent* for 1-2 minutes until all excess resins has been removed.
Do not soak in acetone. Do not leave the 3D part soaking in the liquid. Use a soft brush if necessary.
Clean off any excess of liquid with a cold blowdryer or compressed air.
Leave under the sun or in a UV lamp to cure. The resin is fully cured when fingernails do not leave scratch marks on the object.
*We do not recommend the use of denatured or isopropyl alcohol (IPA). It is very aggressive on the polymerized resin and it could weaken the structure of the 3D part. It is also flammable and potentially harmful to people and the environment.
Store the resin in a dry, cool, shaded place out of direct sunlight.
More information about Standard Blend is available at FunToDo.
The company I.D.M di Marin Davide is not a manufacturer of medical materials or devices. The material sold on this site is neither produced nor controlled by the company I.D.M. di Marin Davide, who in no case can be held responsible for any damage caused by use or application of the material, which must only be used on suitable machines and by specialized personnel, exclusively for the purpose indicated, according to the manufacturer’s instructions. For resins with European certification, the properties of the finished product vary according to the entire printing and post-curing process; refer to the manufacturer for any information about it.
There are no reviews yet.