Harz Labs Jewelry J-Cast 3D Printing Resin

Description

3D printing resin Harz Labs J-Cast has properties of casting waxes. It allows you to print castable jewelry and engineering models, such as rings, bracelets, rings, radiators, adapters, casing, gear blanks, stamps and etc. The material is burned out in wax mode and is compatible with gypsum investment. Low odor and absence of harmful monomers enables working with it even in a small workshop.

 

Russian certification. Product without european certification, to be used only for models.

COMPATIBLE WITH MAIN DLP/LCD 3D PRINTERS

 

3D printing settings on most widespread 3D printers

click here

 

3D printing resin Harz Labs Jewelry J-Cast characteristics

 

Appearance		Colored transparent liquid
Color		Transparent blue
Ash Content		< 0.1 %
Hardness (Shore D)		–
Odor		Odorless
Shrinkage		<1%
Viscosity (Brookfield)	at 25°C	80±50 mPа·s

 

Advantages

 

• ACCURATE

  Provides high precision printing.

• ODORLESS

  Resins are odorless and cause no irritation, so you can work with natural ventilation.

• LOW SHRINKAGE

  Shrinkage less than 0.5% gives you the same size of the 3D model on your computer.

• ZERO ASH CONTENT

  Close to zero ash content (<0.1%) and high strength makes it possible to cast precise metal and ceramic products. 

• STABLE

  Resin is very stable. You can leave it for long time in the vat, no sedimentation and gel formation occur – no need to mix.

• EASY TO CAST

  Thermoplastic behavior of the resin provides melting in wide temperature window (250-300°C) to give very smooth surface of casted models.

Finishing Instructions

 

1. To clean and remove excess resin, flash the 3D printed part for 30 seconds, several times until excess resin is removed, in an ultrasonic cleaner with TEK1960* .

2. Do not soak in acetone. Do not leave the 3D part soaking in the liquid. Use a soft brush if necessary.

3. Clean off any excess of liquid with a cold blowdryer or compressed air.

4. Leave under the sun or in a UV lamp to cure. The resin is fully cured when fingernails do not leave scratch marks on the object.

*We do not recommend the use of denatured or isopropyl alcohol (IPA). It is very aggressive on the polymerized resin and it could weaken the structure of the 3D part. It is also flammable and potentially harmful to people and the environment.

Store the resin in a dry, cool, shaded place out of direct sunlight.

 

Safety notice

 

The company I.D.M di Marin Davide is not a manufacturer of medical materials or devices. The material sold on this site is neither produced nor controlled by the company I.D.M. di Marin Davide, who in no case can be held responsible for any damage caused by use or application of the material, which must only be used on suitable machines and by specialized personnel, exclusively for the purpose indicated, according to the manufacturer’s instructions. For resins with European certification, the properties of the finished product vary according to the entire printing and post-curing process; refer to the manufacturer for any information about it.

 

 More Information                     MSDS