Dental Peach 3D printing resin is matt pale orange colored resin made of biocompatible raw materials that used in UV-cured dental fillings.
It has high hardness 87 Shore D and high tensile strength, stability to mechanical and thermal stress.
We recommend to use it for demonstration and master-model printing. Low odor and absence of harmful monomers allows to print in the laboratory.
Russian certification. Product without European certification, to be used only for models.
COMPATIBLE WITH MAIN DLP/LCD 3D PRINTERS
3D printing settings on most widespread 3D printers
3D printing resin Harz Labs Dental Peach characteristics
|dental demonstration models
|Opaque Pale orange
|Hardness (Shore D)
|Elongation at break
Very precise resin, able to print dental models where exact size and fitting is a must
Models has long-term stability under 100°. Also has short-term stability up to 180°C and can be used for films thermosettling
Resins are odorless and cause no irritation, so you can work with natural ventilation.
Shrinkage less than 0.5% gives you the same size of the 3D model on your computer
Produced from biocompatible raw material used in photopolymer teeth fillings. Meets the standards ISO 10993.
Pigments and fillers are well stabilized, no sedimentation and flocculation occur and no foam appears
Agitate in a vat with TEK1960* solvent for 1-2 minutes to remove excess resin.
Do not soak in acetone. Do not leave the 3D part soaking in the liquid. Use a soft brush if necessary.
Clean off any excess of liquid with a cold blowdryer or compressed air.
Leave under the sun or in a UV lamp to cure. The resin is fully cured when fingernails do not leave scratch marks on the object.
*We do not recommend the use of denatured or isopropyl alcohol (IPA). It is very aggressive on the polymerized resin and it could weaken the structure of the 3D part. It is also flammable and potentially harmful to people and the environment.
Store the resin in a dry, cool, shaded place out of direct sunlight.
The company I.D.M di Marin Davide is not a manufacturer of medical materials or devices. The material sold on this site is neither produced nor controlled by the company I.D.M. di Marin Davide, who in no case can be held responsible for any damage caused by use or application of the material, which must only be used on suitable machines and by specialized personnel, exclusively for the purpose indicated, according to the manufacturer’s instructions. For resins with European certification, the properties of the finished product vary according to the entire printing and post-curing process; refer to the manufacturer for any information about it.