Harz Labs Dental Soft Pink 3D printing resin is designed for digital manufacturing of gingiva mask. Good flexibility and softness required for simulating real gingiva behavior.
Dental Soft Pink resin is created to replace silicone-like material that used in dentistry for precise reproduction of the gingiva mask with perfect fitting and natural aesthetic of the finished product. Mechanical properties are close to real gingiva: good flexibility and softness required for simulating gingiva behavior of patients when adjusting prostheses properly. Stable odorless material designed to be used with Dental Peach resin. Certified for medical use (Russian Market only; Registration certificate for medical device № RZN 2020/12007 , Federal Service for Surveillance in Healthcare).
Russian certification. Product without european certification, to be used only for models.
COMPATIBLE WITH MAIN DLP/LCD 3D PRINTERS
3D printing settings on most widespread 3D printers
3D printing resin Harz Labs Dental Soft Pink characteristics
|Applications||dental demonstration models of gingiva|
|Viscosity (Brookfield)||at 25°C||0.5-0.8 Pa.s|
|Hardness (Shore D)||87-90|
|Tensile strenght||1.2 N/mm2|
|Elongation at break||68 %|
UNIQUE MECHANICAL PROPERTIES
Very high hardness, tensile strength, abrasion and scratch resistance due to ceramic fillers.
The resin has relatively low viscosity. It decreases time for levelling, easy to clean to provide maximum accuracy at minimum time.
Resin is stable to solvents, aggressive inorganic agents like acid and alkalis.
Resins are odorless and cause no irritation, so you can work with natural ventilation.
Shrinkage less than 0.5% gives you the same size of the 3D model on your computer
Produced from biocompatible raw material used in photopolymer teeth fillings. Meets the standards ISO 10993.
Pigments and fillers are well stabilized, no sedimentation and flocculation occur and no foam appears
Agitate in a bath with TEK1960* solvent for 1-2 minutes to remove excess resin.
Do not soak in acetone. Do not leave the 3D part soaking in the liquid. Use a soft brush if necessary.
Clean off any excess of liquid with a cold blowdryer or compressed air.
Leave under the sun or in a UV lamp to cure. The resin is fully cured when fingernails do not leave scratch marks on the object.
*We do not recommend the use of denatured or isopropyl alcohol (IPA). It is very aggressive on the polymerized resin and it could weaken the structure of the 3D part. It is also flammable and potentially harmful to people and the environment.
Store the resin in a dry, cool, shaded place out of direct sunlight.
The company I.D.M di Marin Davide is not a manufacturer of medical materials or devices. The material sold on this site is neither produced nor controlled by the company I.D.M. di Marin Davide, who in no case can be held responsible for any damage caused by use or application of the material, which must only be used on suitable machines and by specialized personnel, exclusively for the purpose indicated, according to the manufacturer’s instructions. For resins with European certification, the properties of the finished product vary according to the entire printing and post-curing process; refer to the manufacturer for any information about it.