Description
Before buying please read what post-processing is required due your device.
3D printing resin Harz Labs Dental Bleach PRO is a resin with PMMA-type ceramic micro filling, made of biocompatible raw materials. It has high durability and high tensile strength, resistant to mechanical and chemical effects. Recommended for printing models of temporary crowns and bridges. The slight odor and lack of hazardous monomers allow for using it even in a small room.
Russian certification. Product without european certification, to be used only for models.
COMPATIBLE WITH MAIN DLP/LCD 3D PRINTERS
3D printing settings on most widespread 3D printers
3D printing resin Harz Labs Dental Bleach PRO characteristics
| Appearance | Opaque liquid | |
| Color | Bleach | |
| Elongation at break | 4.1 ± 1.1% | |
| Hardness (Shore D) | 96 ± 3 | |
| Odor | Weak odor | |
| Shrinkage | <0.5% | |
| Elastic modulus | 3200 ± 200 MPa | |
| Viscosity (Brookfield) | at 25°C | 600-1200 mPa·s |
Advantages
-
STABLE COLOR
Depending on postcuring condition. Bleach color is achievable. It is stable for a long time even in aggressive media.
-
DURABLE
Pigments and fillers are well stabilized, no sedimentation and flocculation occur ang no foam appears.
-
LOW SHRINKAGE
Shrinkage less than 0.5% gives you the same size of the 3D model on your computer.
-
SAFE
Resin does not contain solvents and volatile monomers, irritating compounds. No fumes, odor and allergic reaction. Сan be used in lab or even at home.
-
BIOCOMPATIBLE
Produced from biocompatible raw material used in photopolymer teeth fillings. Meets the standard ISO 10993.
-
UNIQUE MECHANICAL PROPERTIES
Very high hardness, tensile strength, abrasion and scratch resistance due to ceramic fillers.
-
CERTIFICATION
Biocompatibility was confirmed by the third-party laboratories. Material was successfully tested in accordance with ISO 10993 with the provision of the MA No. RZN 2020/12007.
Finishing Instructions
-
To clean and remove excess resin, flash the 3D printed part for 30 seconds, several times until excess resin is removed, in an ultrasonic cleaner with TEK1960* .
-
Do not soak in acetone. Do not leave the 3D part soaking in the liquid. Use a soft brush if necessary.
-
Clean off any excess of liquid with a cold blowdryer or compressed air.
-
Leave under the sun or in a UV lamp to cure. The resin is fully cured when fingernails do not leave scratch marks on the object.
*We do not recommend the use of denatured or isopropyl alcohol (IPA). It is very aggressive on the polymerized resin and it could weaken the structure of the 3D part. It is also flammable and potentially harmful to people and the environment.
Store the resin in a dry, cool, shaded place out of direct sunlight.
Safety notice
The company I.D.M di Marin Davide is not a manufacturer of medical materials or devices. The material sold on this site is neither produced nor controlled by the company I.D.M. di Marin Davide, who in no case can be held responsible for any damage caused by use or application of the material, which must only be used on suitable machines and by specialized personnel, exclusively for the purpose indicated, according to the manufacturer’s instructions. For resins with European certification, the properties of the finished product vary according to the entire printing and post-curing process; refer to the manufacturer for any information about it.
Reviews
There are no reviews yet.