Designed for printing individual impression trays with high printing speed and accuracy. it has the necessary retention to dental impression materials. meets the requirements of iso 10993.
Dental Tray designed for printing individual impression trays. Strong and stable over time resin, providing long-term storage of the silicone impression. The possibility of printing with a layer up to 200 microns allows you to reduce the production time. Slight odor and lack of hazardous monomers allow this dental 3D printing resin to be used even in a small laboratory.
Russian certification. Product without european certification, to be used only for models.
COMPATIBLE WITH MAIN DLP/LCD 3D PRINTERS
3D printing settings on most widespread 3D printers
3D printing resin Harz Labs Dental Tray characteristics
|Viscosity (Brookfield)||at 25°C||600+-200 mPa.s|
|Hardness (Shore D)||85+-5|
|Tensile strenght||60 mPa|
|Elongation at break||6+-3%|
Models have long-term stability at 100°C making it possible to cast in both cold and hot silicone moulds.
Resins are odorless and cause no irritation, so you can work with natural ventilation.
Shrinkage less than 0.5% gives you the same size of the 3D model on your computer
Produced from biocompatible raw material used in photopolymer teeth fillings. Meets the standards ISO 10993.
Resin is very stable. You can leave it for long time in the vat, no sedimentation and gel formation occur – no need to mix.
Very high hardness and tensile strength.
Agitate in a bath with TEK1960* solvent for 1-2 minutes to remove excess resin.
Do not soak in acetone. Do not leave the 3D part soaking in the liquid. Use a soft brush if necessary.
Clean off any excess of liquid with a cold blowdryer or compressed air.
Leave under the sun or in a UV lamp to cure. The resin is fully cured when fingernails do not leave scratch marks on the object.
*We do not recommend the use of denatured or isopropyl alcohol (IPA). It is very aggressive on the polymerized resin and it could weaken the structure of the 3D part. It is also flammable and potentially harmful to people and the environment.
Store the resin in a dry, cool, shaded place out of direct sunlight.
The company I.D.M di Marin Davide is not a manufacturer of medical materials or devices. The material sold on this site is neither produced nor controlled by the company I.D.M. di Marin Davide, who in no case can be held responsible for any damage caused by use or application of the material, which must only be used on suitable machines and by specialized personnel, exclusively for the purpose indicated, according to the manufacturer’s instructions. For resins with European certification, the properties of the finished product vary according to the entire printing and post-curing process; refer to the manufacturer for any information about it.
There are no reviews yet.