Description
Dental Yellow Clear PRO is a hard PMMA-like resin, made of biocompatible raw materials. It is designed for printing autoclavable transparent models of surgical guides. Precise, chemical resistant, and durable. The slight odor and lack of hazardous monomers allow for using it even in a small laboratory.
Russian certification. Product without european certification, to be used only for models.
COMPATIBLE WITH MAIN DLP/LCD 3D PRINTERS
3D printing settings on most widespread 3D printers
3D printing resin Harz Labs Dental Yellow Clear PRO characteristics
| Appearance | Colored transparent liquid | |
| Odor | Weak odor | |
| Color | Transparent Yellow | |
| Viscosity (Brookfield) | at 25°C | 600 ± 200 mPa·s |
| Hardness (Shore D) | 85.0 ± 3.0 | |
| Tensile strength | 80.0 ± 5.0 MPa | |
| Elongation at break | 10 ± 3.0 % | |
| Shrinkage | <0.5% |
Advantages
-
SAFE
Resin does not contain solvents and volatile monomers, irritating compounds. No fumes, odor and allergic reaction. Сan be used in lab or even at home.
-
ACCURATE
Provides high precision printing.
-
LOW SHRINKAGE
Shrinkage less than 0.5% gives you the same size of the 3D model on your computer.
-
BIOCOMPATIBLE
Produced from biocompatible raw material used in photopolymer teeth fillings. Meets the standards ISO 10993.
-
CERTIFICATION
Biocompatibility was confirmed by the third-party laboratories. Material was successfully tested in accordance with ISO 10993 with the provision of the MA No. RZN 2020/12007.
-
DURABLE
Very high hardness and tensile strength.
-
LIQUID
The resin has relatively low viscosity. It decreases time for levelling, easy to clean to provide maximum accuracy at minimum time.
Finishing Instructions
-
Agitate in a bath with TEK1960* solvent for 1-2 minutes to remove excess resin.
-
Do not soak in acetone. Do not leave the 3D part soaking in the liquid. Use a soft brush if necessary.
-
Clean off any excess of liquid with a cold blowdryer or compressed air.
-
Leave under the sun or in a UV lamp to cure. The resin is fully cured when fingernails do not leave scratch marks on the object.
*We do not recommend the use of denatured or isopropyl alcohol (IPA). It is very aggressive on the polymerized resin and it could weaken the structure of the 3D part. It is also flammable and potentially harmful to people and the environment.
Store the resin in a dry, cool, shaded place out of direct sunlight.
Safety notice
The company I.D.M di Marin Davide is not a manufacturer of medical materials or devices. The material sold on this site is neither produced nor controlled by the company I.D.M. di Marin Davide, who in no case can be held responsible for any damage caused by use or application of the material, which must only be used on suitable machines and by specialized personnel, exclusively for the purpose indicated, according to the manufacturer’s instructions. For resins with European certification, the properties of the finished product vary according to the entire printing and post-curing process; refer to the manufacturer for any information about it.
Reviews
There are no reviews yet.